Your furnace is a key part of your home. Without one, you wouldn’t be able to stay warm during cold weather. Yet furnaces can have some issues that are more typical than others.

Let’s go over these problems and discuss what they might cost to correct so you know before you call an HVAC technician. Some of the most common furnace repair issues include:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Isn’t Turning On

There are a few reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set right? Make sure it’s on “heat,” “auto” and that your preferred temperature is greater than the room’s current temperature. If you have a programmable thermostat, make sure it has new batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have power. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or near it. Because this switch resembles a light switch, it’s easy to accidentally turn it off. If it was off, it might take your furnace a few minutes to start.
  • Is the air filter clean? A dirty air filter can create a lot of issues for your furnace. Get a new one if you can’t see light through it.

Estimated Repair Cost

This problem can be complicated, so the estimated cost to repair it varies according to what’s wrong.

2. The Furnace Won’t Stay Lit

Your furnace uses a specific sequence when it begins heating your home.

  1. Your thermostat detects the temperature has dropped and tells your furnace to start running.
  2. The draft inducer fan turns on to bring in fresh air for combustion.
  3. The gas valve opens for the burners, which are ignited electronically.
  4. The flame sensor tells your furnace the burners have been lit.

If something is wrong during the sequence, your furnace will shut down as a safety precaution.

A couple of potential causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to prevent natural gas from getting into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be replaced.
  • Bad limit switch. This safety feature will shut off your furnace if it detects backdrafting. Backdrafting is hazardous, since carbon monoxide and natural gas can leak into your home. These switches can malfunction due to age, damage or dust buildup.
  • Old thermostat. If your thermostat isn’t working properly, your furnace won’t be able to run.
  • Dirty air filter. A dirty air filter can reduce airflow and cause your furnace to shut down to prevent overheating. Make sure to replace yours every 30 to 90 days, or whenever you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. My Furnace Is Blowing Cold Air

In many instances, this problem is tied to a wrong thermostat setting or a dirty air filter that’s limiting airflow. Use the steps above to fix the problem.

4. My Furnace Can’t Shut Down

If it’s very chilly outside or you like your home to be warm, your furnace may be working for a long time.

If this isn’t what’s happening, make sure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be running even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Alternatively, there might be a problem with the blower motor or your ductwork may be losing air, forcing your furnace to run continuously to make up for the lost air.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on house size

SKC AC LLC Will Work Hard to Get to the Bottom of Your Furnace Issues as Soon as Possible

Furnace problems can be an expensive headache, but not when you call SKC AC LLC. We’ve been delivering the quality, affordable furnace repair Big Spring homeowners have relied on since year. Call us at 432-203-4881 to receive your free estimate today.